How to install steel factory building with crane?

Crane is one of the indispensable important equipment in modern industrial production, it can efficiently complete the handling and lifting tasks of various materials. In order to ensure the safe and normal operation of the crane, a series of preparatory work and operation steps are required when the crane is installed in the steel factory building.

The structural assessment and design of the steel factory building was required prior to the installation of the crane. This includes assessing the load-bearing capacity of the plant, determining where the cranes will be located and the required lifting heights. Depending on the type of crane and the demands of the job, the support structure and foundation reinforcement required to install the crane also need to be considered.

Then, carry out the selection and purchase of the crane. According to the use requirements of the workshop and the weight of the lifted materials, select the appropriate crane model and specification. At the same time, it is also necessary to consider the brand and quality of the crane, and choose a reliable supplier for purchase.

After the crane arrives, it needs to be assembled and installed. First of all, according to the installation drawing of the crane, determine the hoisting point and the arrangement position of the crane. The crane is then hoisted using a crane or hoist to install it on a pre-designed support structure. During the hoisting process, it is necessary to strictly abide by the hoisting operating procedures to ensure safety.

After the crane is installed, it needs to be commissioned and tested. First of all, check whether the running parts and connecting parts of the crane are installed firmly and whether they are loose or worn. Then, debug the electrical wiring and control system of the crane. During the commissioning process, it is necessary to ensure that the functions of the crane are normal, the operation is stable, and the relevant safety standards are met.

After the commissioning of the crane is completed, a trial run of the crane is required. During the trial run, it is necessary to test various functions and working performance to ensure that the crane can operate normally and meet the working requirements of the workshop. At the same time, it is also necessary to test the various safety protection devices of the crane to ensure that the operation of the crane can be stopped in time to avoid accidents when abnormal conditions occur.

Finally, acceptance and training of the crane is required. During the acceptance process, it is necessary to check whether the installation quality and working performance of the crane meet the relevant standards and requirements. If the requirements are met, the crane can be officially used. At the same time, it is also necessary to provide crane operation and maintenance training to the workshop staff to ensure that they can operate the crane correctly and perform daily maintenance and overhaul in a timely manner.

In short, the installation of the steel factory building with crane is a complex and important project that requires careful operation through multiple steps and links. Only on the basis of full preparation and strict operation can the safe and normal operation of the crane be ensured, and the production efficiency and work quality of the workshop can be improved. Therefore, when installing the crane in the workshop, it is important to pay attention to details to ensure that every link is handled carefully.